Your cart is empty!
Big fruiting bags with the air exchange a large block needs.
Blue Myco XLS double patch bags are built for fruiting, not just colonizing. Each 10" x 5.5" x 24" gusseted bag has two oversized 3.8" x 3.8" filter patches rated 0.5 micron, about 29 square inches of filter per bag, so a big block gets the air exchange it needs once it starts producing mushrooms.
Fruiting bodies burn oxygen and give off CO2 far faster than colonizing mycelium. A small grain-bag filter can choke a fruiting block; two large, more open patches keep the air moving so you can colonize sealed and then fruit straight out of the bag.
Each 3.8" patch has more than six times the area of a standard 1.5" patch, and the pair gives this bag the most filter area in the Blue Myco lineup.
Colonize the block sealed, then cut the bag open where you want mushrooms and fruit directly out of it.
3.0 mil (80 micron) polypropylene with side gussets holds a large, heavy block without splitting.
Fill with substrate, keeping both filter patches clear.
Fold and clip the top, then pressure sterilize. A large, dense block needs a longer cycle than a small bag.
Cool to room temperature, mix in grain spawn in clean air and heat-seal the bag.
Let the block colonize fully, then cut the bag to start fruiting conditions.
Fruiting bag or spawn bag? If the block leaves the bag before it fruits, use a spawn bag. If it fruits while still in the bag, use a double patch fruiting bag. The 0.5 micron rating is deliberately more open than the 0.2 micron patch on grain bags, so these are the wrong choice for long sealed grain runs.
Complete the setupFill with bulk substrate, inoculate with grain spawn and close each bag with the PFS-300 impulse sealer.
A large fruiting block needs far more gas exchange than colonizing grain. Two 3.8" patches give about 29 square inches of filter area so CO2 can escape and fresh air can get in.
They aren't the best choice. The 0.5 micron patches are more open than the 0.2 micron patches on grain bags. For long sealed grain runs, use a spawn bag.
Yes. Fold and clip the top instead of sealing so the bag can vent, and give large, dense blocks a longer cycle.
Once the block is fully colonized, cut slits or open the top of the bag where you want mushrooms to form, then give it fruiting conditions.
I just switched to these from shoebox tubs. So glad I took a chance and tried them. They easily hold twice as much and are working better for me personally. Very durable and plenty of FAE Highly recommended