Home > Mushroom Growing Supplies
Products 73-95 of 95
Show
Availability: In Stock
Myco Labs
Item #: H1 -
Everything you need for filtered, automatic humidity in one box, pump included. A quiet 2.5W air pump pushes air through an inline HEPA filter into a water-filled humidifier, where it picks up fine droplets from Hydroton and synthetic fiber media and leaves as a steady stream of humid air. It suits bulk casing setups and tubs where perlite is not practical, and it needs no drilled holes. 2.5WPump included HEPAInline filter HydrotonPlus synthetic fiber 10mmOutput hose No drillingRequired Why...
Availability: In Stock
Myco Labs
Item #: H2 -
A replacement or add-on hydroponic humidifier for fruiting chambers and tents. Air from an aquarium pump (sold separately) passes through an inline HEPA filter, bubbles through water and Hydroton media, and leaves as clean, humid air through a 10mm output hose. It works with most pump-driven humidifier setups. HEPAInline intake filter HydrotonHumidifier media 10mmOutput hose PumpSold separately Why use it Filtered airA blue silicone intake hose with an inline HEPA filter keeps the air going in...
Featured!
Spotlight!
Availability: In Stock
Microppose
Item #: DD5 -
The Microppose Deep Draw is a 5 in, 16-gauge sterile needle made for mycology. It reaches the bottom of a liquid culture jar and deep into grain jars and spawn bags, and the 16G bore lets thick culture flow without clogging. Standard needles are about 1.5 in long, so you end up tipping jars to chase the last of your culture. Each needle is individually wrapped and fits any Luer lock syringe. 5 inNeedle length 16GGauge SterileIndividually wrapped Luer lockFitting 5Per pack Why use the Deep Draw...
Availability: In Stock
Grower's Select
Item #: MM1 -
The Mushroom Monsoon is a 3.0 L humidifier built for terrariums and greenhouses rather than living rooms. Its atomizer makes a much finer mist than a household unit, so it adds humidity to a fruiting chamber without soaking it. Stretch tubing runs 18 to 66 inches, and it shuts itself off when the tank runs dry. 3.0 LReservoir (102 oz) SuperfineMist 18–66"Stretch tubing AutoDry-run shutoff TimerCompatible Why growers use the Monsoon Fine mist, not puddles Household humidifiers are made for...
Availability: In Stock
Myco Labs
Item #: PF1 -
Polyfil is the simple way to filter the air holes in a monotub or fruiting chamber. A loose plug in each hole lets fresh air in while slowing spores and dust on their way to your substrate. One overfilled quart bag covers 2-3 standard tubs. 1 qtOverfilled bag 2-3Tubs per bag SyntheticPolyfil fiber Why growers use polyfil BreathableAir moves through while airborne contaminants are slowed down. AdjustablePack it tighter or looser to tune airflow. Any tubWorks in any bulk casing setup or DIY...
Hot!
Availability: In Stock
Item #: MSB9 -
This is the full factory case: 1,000 Unicorn medium 10T bags, the same 5" x 4" x 18" gusseted bag as our 50-pack at case pricing. At 3 to 4 pounds of grain per bag, one case runs roughly 3,000 to 4,000 pounds of spawn, which makes it the right buy for farms, labs and spawn producers filling bags every week. Unicorn bags are made in the USA by the company that created the filter patch spawn bag. The film carries pliability additives so it stays flexible after sterilization instead of...
Hot!
Availability: In Stock
Item #: MSB1 -
Unicorn medium 10T bags are the grain bag most growers learn on: a 5" x 4" x 18" gusseted bag with a 0.2 micron filter patch that holds 3 to 4 pounds of hydrated grain. That is enough to spawn a tub, light enough to break and shake by hand, and small enough that one contaminated bag doesn't sink a whole run. Unicorn bags are made in the USA by the company that created the filter patch spawn bag. The film carries pliability additives so it stays flexible after sterilization instead of...
Availability: In Stock
Myco Labs
Item #: SCP5 -
Disposable sterile scalpels for agar work, tissue cloning and transfers, five to a pack. Each one is individually wrapped with a #10 tempered high-carbon stainless steel blade and a protective cap, so every cut starts with a fresh, sterile edge. Using a new blade for each culture is one of the easiest ways to stop cross-contamination, and the ergonomic handle has a ruler on the side for quick measuring. 5Scalpels per pack #10Blade StainlessHigh-carbon, tempered SterileIndividually wrapped...
Availability: In Stock
Myco Labs
Item #: ECL8 -
A heavy-duty 8mm drip liner that sits under your grow tent and catches condensation, humidifier drips and substrate runoff before they reach your floor. It is pre-cut to 29" x 19.5" with 3" self-supporting walls, so there is nothing to fold, tape or prop up. It is the replacement liner for Ecosphere greenhouse systems and also fits our 4 and 5 tier Martha tents, which use the same frame. 8mmFood-safe LDPE 29" x 19.5"Footprint 3"Self-supporting walls 4 & 5 tierFits ReusableWipe clean Why...
Availability: In Stock
Myco Labs
Item #: HM1 -
A 21" x 11" under-tank heating mat with a liquid graphite core that spreads heat evenly across the whole surface. Wire-based heating pads can create hot spots that dry out substrate or warp plastic bins; this mat avoids that. It gives gentle bottom heat for monotubs, incubation bins, grain jars and spawn bags, uses just 28 watts, and has an adjustable dial from about 67 to 86 F. 21" x 11"Size 28WPower use GraphiteInfrared heat 67-86 FDial range 110-120VOnly Why growers use it No hot spotsThe...
Availability: In Stock
Microppose
Item #: FD1 -
Synthetic filter discs that turn a standard 90mm wide-mouth canning lid into a breathable, contamination-resistant jar lid. Each disc filters to 0.22 micron, and the media is hydrophobic and oleophobic, so condensation and oils don't clog it during incubation. They're made to be reused: autoclave them with the jar, wash and dry them after the run, and put them back on the next batch. Add a self-healing injection port to the lid and you have a complete DIY inoculation lid. 90mmDiameter 0.22...
Availability: In Stock
Microppose
Item #: MLP1 -
Microppose Laboratory Poly Film is a stretchy, scissor-free way to seal petri dishes. Pull a length off the roll, tear it by hand and stretch it around the rim. It clings to itself to lock moisture in, and sealed plates won't fuse together when you stack them. It's what we use on plates in our own lab. One 1.25" x 280 ft roll seals hundreds of 90 mm dishes. 1.25"Width (32 mm) 280 ftPer roll No toolsTears by hand ElasticStretches to seal Non-stickStacks cleanly Why growers switch to it No...
Availability: In Stock
Myco Labs
Item #: MD1 -
A small, inexpensive gauge that shows temperature and humidity on one LCD screen. It updates every 5 seconds, reads humidity within plus or minus 2%, and is small enough to tuck inside a tub, tent or incubation chamber. +/-2%RH accuracy 5 secRefresh 10-99%Humidity range 0.6 ozWeight Why growers use it Dual displayTemperature and humidity on one screen. Wide ranges-58°F to 158°F and 10-99% RH. Fits anywhere1.89 x 1.13 x 0.6 in and very light. How to use it 1Place itSet it inside your...
Availability: In Stock
Item #: ULB1 -
Unicorn large 3T bags are the big-batch grain bag: 8" x 5" x 19" and gusseted, holding 5 to 6 pounds of hydrated grain or substrate with a 0.2 micron filter patch. Fewer, bigger bags mean less filling and handling per run. Unicorn bags are made in the USA by the company that created the filter patch spawn bag. The film carries pliability additives so it stays flexible after sterilization instead of stiffening, and the bottom seal is built to hold up to the shaking a grain run takes. 50 bagsPer...
Availability: In Stock
Blue Myco Systems
Item #: BMLX -
Blue Myco XLS double patch bags are built for fruiting, not just colonizing. Each 10" x 5.5" x 24" gusseted bag has two oversized 3.8" x 3.8" filter patches rated 0.5 micron, about 29 square inches of filter per bag, so a big block gets the air exchange it needs once it starts producing mushrooms. Fruiting bodies burn oxygen and give off CO2 far faster than colonizing mycelium. A small grain-bag filter can choke a fruiting block; two large, more open patches keep the air moving so you can...
Availability: In Stock
Myco Labs
Item #: d01 -
Dry your harvest without heat or electricity. Fresh mushrooms sit on a mesh screen inside a clear 6.5-quart chamber, above two desiccants that pull moisture out of the air until the mushrooms are cracker-dry. Because the chamber is sealed, it works even in a humid room, and the desiccants recharge in the oven so you can use the kit again and again. 6.5 qtClear chamber 4 ozActivated alumina 4 ozSilica gel 0.5 mmMesh screen 250°FTo recharge Why use a desiccant drying kit No heatThe...
Availability: In Stock
Myco Labs
Item #: PNC3 -
Sterile 6mm agar punches cut clean, round plugs of agar and mycelium for transfers, cloning and isolation. Each punch comes individually wrapped and sterile, with a tempered stainless-steel blade and a plastic handle for a secure grip. A round 6mm plug sits flat on fresh agar and grows out evenly in every direction, which makes it easier to compare cultures side by side and pick the healthiest growth. 2 punchesPer pack 6mmRound cut SterileIndividually wrapped StainlessTempered blade...
Availability: Out of Stock
Blue Myco Systems
Item #: BML1 -
This is a full case of 800 Blue Myco large 3T bags: the 8" x 5" x 19" gusseted bag in a heavier 3.0 mil film, at case pricing for operations that fill bags on a schedule. The thicker film takes aggressive sealing and repeated handling through filling, sterilizing and incubation without micro-tears, stays pliable after sterilization, and has a reinforced bottom seal. 800 bagsFull case 8" x 5" x 19"Gusseted 3.0 mil80 micron film 0.2 micronFilter patch ReinforcedBottom seal Why growers pick Blue...
Availability: In Stock
Myco Labs
Item #: TM1 -
Mushrooms fruit best when lights, fans and humidifiers run on a schedule they can count on. This heavy-duty 110V plug-in timer handles it for you: set up to 48 on/off changes a day in 30-minute steps, and it repeats the same pattern every 24 hours until you change it. 48Cycles per day 30 minSteps 110VPlug-in 24 hrRepeating Why use a timer Consistent lightA steady daily light cycle is easy to keep when it is automated. Set it onceProgram the schedule one time and it repeats every day. Runs more...
Availability: In Stock
Myco Labs
Item #: SD1 -
Silica gel drying canisters keep dried mushrooms from picking up moisture in storage. Drop a few into a bag, jar or container and the 2g of silica gel in each vented canister soaks up humidity to help prevent mold. They can also finish an almost-dry batch: seal a handful in the bag and it's typically cracker-dry within about 24 hours. 25Canisters 2gSilica gel each 4–5Per ½ oz dried 1–6 moStorage window VentedFood-safe housing Why use silica gel canisters Absorbs moisture Pulls humidity out of...
Availability: In Stock
Myco Labs
Item #: DK6 -
A refill of the same two desiccants used in our Easy Mushroom Drying Kit, in bigger 6 oz portions. Silica gel pulls moisture out fast at the start, and activated alumina keeps working after the silica gel is full. Blue indicator beads in the silica gel turn pink when it needs recharging, and both desiccants come back to full strength after an hour in the oven. 6 ozSilica gel 6 ozActivated alumina Blue to pinkWhen saturated 250°FRecharge temp ~60 minRecharge time Why two desiccants Fast...
Availability: In Stock
Myco Labs
Item #: SP1 -
The basics for a clean injection in one small pack, so you do not have to buy needles, pads and gloves in bulk. You get five 16G Luer lock needles, ten alcohol prep pads, a pair of nitrile gloves and a face mask, enough for several inoculations of grain bags, jars or other substrates. The needles fit most spore and liquid culture syringes. 516G needles 10Alcohol prep pads 1 pairNitrile gloves 1Face mask Luer lockFitting Why grab a pack All in oneNeedles, pads, gloves and a mask for clean...
Availability: Out of Stock
Myco Labs
Item #: MM2 -
Run two or more greenhouses or fruiting chambers from one Monsoon humidifier. This expansion pack splits the Monsoon output with a Y splitter and stretch tubing, so you can grow your setup without buying a second unit. YSplitter 18-66"Stretch tubing 12"Clear connector 2Suction mounts 1 unitFeeds 2+ chambers Why growers add it Use one humidifierFeed a second tent or chamber from the Monsoon you already own. Flexible reachThe black tubing stretches from 18" to 66". Easy to mountSuction cups hold...